Wireless Doorbell Camera & Smart Chime

Install a No-Drill Doorbell Mount

This no-drill mount allows you to install your Frontpoint Wireless Doorbell Camera securely without drilling into your door or frame. It is adjustable to fit most door thicknesses and is designed for inward-opening doors.

Before You Begin

• Confirm your door opens inward

• Make sure the door edge is clean and dry

• Have all included foam pads, spacers, and screws ready

Step 1: Prepare the Mount

Apply the included round adhesive pads to the areas of the mount that will touch your door.

• These pads help protect the door’s surface and keep the mount stable.

Step 2: Adjust the Foam Insert

Place the adjustable foam insert inside the doorbell holder.

• Insert your doorbell to check the fit

• Add or remove foam layers as needed

• The doorbell should fit snugly with no movement

Step 3: Insert the Doorbell

Slide the doorbell into the holder with:

• The camera lens centered in the opening

• The button fully accessible

Step 4: Secure the Doorbell

Attach the cover to the holder and tighten the screws to hold the doorbell in place.

• Do not overtighten.

Step 5: Assemble the Clamp

Attach the mounting bracket to the base.

• Insert the plastic nut with the foam side facing the door

• Thread the tightening screw through the bracket

• Ensure all spacers are seated correctly

Step 6: Install on the Door

Slide the assembled mount over the top edge of the door on the interior side.

• Align the doorbell so it sits straight

• Hand-tighten the screw until the mount is secure

  • Tighten only until snug to avoid damaging the door.

Step 7: Test the Installation

Slowly open and close the door to confirm:

• The door moves freely

• The mount remains stable

• The camera view is clear

Make adjustments if needed.