Z-wave device is reporting low battery
Low Battery: Z-Wave Device
If a Z-Wave Device reports a low battery, we recommend replacing it as soon as possible (although you will typically have a few weeks before completely drained). Please use the below photos to identify the device which was reported to have a low battery, and refer to the corresponding directions to replace the battery.
This Lock uses 4 AA batteries.
Use the included pin tool or something small such as a paper clip to open the battery compartment
Swap out the 4 AA batteries
Snap the battery cover back in place
This Lock uses 4 AA batteries.
Squeeze the sides of the battery cover to remove it.
Unplug the wire connection from the top of the battery compartment
Slide the battery compartment up out of the lock housing
Swap out the 4 AA batteries
Slide the battery compartment back into the lock housing
Plug the wire connection back in the battery compartment
Snap the battery cover back onto the lock
The thermostat has 2 AAA batteries
Remove the thermostat from the back plate by pulling the thermostat straight out and off the wall.
Take out the existing AAA batteries.
Insert the new batteries following the specified polarity markings on the thermostat
Return the thermostat to the wall plate by pressing the thermostat body firmly into the back plate mounted to the wall.